Print this articlePrint this article

Written by Jerry Smith
As featured on page 67 in the April 2013 issue of
Model Aviation magazine.
Also featured in the
Model Aviation tablet app with bonus video.                    

Model type: Nostalgic park flyer
Skill level: Intermediate builder; intermediate pilot
Wingspan: 36 inch
Wing area: 127 square inches
Airfoil: Flat bottom
Length: 20 inches
Weight: 3 to 5 ounces
Radio: Four channel with two micro servos
ESC: Five amp brushed ESC
Battery: Two-cell 300 mAh
Motor: GWSEPD/50XC
Price: $69.99

Test-Model Details
Radio System: Spektrum DX8 radio; Spektrum AR400 receiver, two GWS micro 3.7 gram servos; GWS100C ESC; 300 mAh 2S battery.
Ready-to-fly weight: 4.7 ounces
Flight duration: 10 minutes (if you get it high and let it glide some)
Construction: Laser cut balsa and ply
Finish: Solite covering material

• Accurate laser-cut parts
• Plug in wing panels
• Easy transportation
• Good scale outline
• Good written instructions

• Instruction pictures too small
• No radio installation information
• Propeller hard to mount on motor shaft
• Required tail weight

These are the completed airframe parts before sanding. The parts were sanded with 220-grit sandpaper and then with 400-grit sandpaper before covering.

With shaping completed on the hatch and nose of the fuselage, the hatch is held in place with two dowels in the back and a magnet in the front. A short dowel keys it in place.

Small plastic guide tubes for the pull-pull linkage are placed to provide exit points in the covering. Sheet four of the instructions explains the routing of pull-pull lines and location of the tubes.

Installing the radio shows how little room is available. Removing some of the bulkheads in the hatch provides room for the battery.

The optional electric-power pod, included when you buy the e’SinBad the Sailor kit 36, is inserted on the wing joiner wires and sandwiched between the wings.

The SinBad exhibits docile flight characteristics in the air, yet it is responsive to control inputs using rudder, elevator, and throttle.


I would like to know who is the distributor for this model of plane. Please email me or call me at (604) 888-4691. Very much appreciated.94

Hi. You can buy this directly through Retro RC at Enjoy!

Add new comment